Snapmaker profile for Cura & Simplify3D

  • Note: Please note that if the printer is damaged because of the third party software, the warranty will be voided. Please see the warranty policy at

Cura settings:

Start Gcode:
  • G28 ;Home
  • G1 Z15.0 F6000 ;Move the platform down 15mm
  • G0 X-4 Y-1 Z0
  • G92 E0
  • G1 F200 E20
  • G92 E0
End Gcode:
  • M104 S0
  • M140 S0
  • ;Retract the filament
  • G92 E1
  • G1 E-1 F300
  • G28 X0 Y0
  • M84

The recommended print speed is less than 40 mm/s, and the recommended travel speed is less than 80 mm/s.


Please click here to download the profile.

results matching ""

    No results matching ""